Cuts involute spline teeth into a bore over exactly length from at, a hub a splined shaft
slides into, by standard. DIN 5480 (din, the default) takes the teeth's module and the
shaft's reference diameter, both in millimetres as the standard names them (25 and 1.25 in
W 25 x 1.25) whatever the document's unit; ANSI B92.1 (ansi) takes the pitch, such as "16/32", and the
number of teeth. With diameter or teeth left out the spline is the one whose hub teeth end on
the bore; a bore wider than the hub's tips is refused. Its faces are named spline.
Cuts involute spline teeth into a bore over exactly
lengthfromat, a hub a splined shaft slides into, bystandard. DIN 5480 (din, the default) takes the teeth'smoduleand the shaft's referencediameter, both in millimetres as the standard names them (25 and 1.25 in W 25 x 1.25) whatever the document's unit; ANSI B92.1 (ansi) takes thepitch, such as"16/32", and the number ofteeth. Withdiameterorteethleft out the spline is the one whose hub teeth end on the bore; a bore wider than the hub's tips is refused. Its faces are namedspline.